Hardwired Smoke Detectors: How They Work and When to Replace Them

A hardwired smoke detector runs on your home's wiring and, on modern units, has a battery for backup. Most hardwired alarms are also interconnected, so when one senses smoke, they all sound. Replace them 10 years after the manufacture date printed on the back (or by the replace-by date, if the alarm shows one), or sooner if they fail a test.

Hardwired vs battery-only vs 10-year sealed alarms

Type Power Interconnected?
Hardwired House wiring plus a backup battery Usually yes
Battery-only Replaceable battery Usually no
10-year sealed Sealed battery you cannot remove Some models link by wireless signal

People also call a hardwired smoke detector a hardwired fire alarm or a wired fire alarm.

How do interconnected smoke alarms work?

Each hardwired alarm connects to three wires in the ceiling box: hot, neutral and a signal wire. The signal wire links every alarm on the system. When one alarm senses smoke, it sends a signal down that wire and every alarm sounds. A fire in the basement wakes people in the bedrooms. Interconnected smoke alarms must be compatible with each other, so check the manufacturer's instructions before you mix makes or models.

What does the backup battery do?

The backup battery keeps the alarm working when the power is out. Some alarms use a battery you change. Others have a sealed backup battery that lasts the life of the unit.

Why is my hardwired smoke detector chirping?

A short chirp about once a minute is a trouble signal, not a fire alarm. Common causes:

  • The backup battery is low or not seated.
  • The alarm has reached the end of its life.
  • The plug on the back is loose, or power to the circuit is off.

Change the battery first and press the test button. If it still chirps, check the date on the back.

When should hardwired smoke detectors be replaced?

NFPA 72, the national fire alarm code, says to replace smoke alarms 10 years after the date of manufacture. Twist the alarm off its base and read the date on the back. Some alarms print a replace-by date instead. If so, go by that date. If it is more than 10 years old, or you cannot find a date, replace the alarm. CO alarms wear out too, so follow the date and instructions on the unit.

Smoke, CO or combination alarm?

A smoke alarm senses smoke from a fire. A carbon monoxide (CO) alarm senses CO gas from fuel-burning equipment, such as a furnace or water heater, or from a car in an attached garage. A combination alarm does both in one unit. One does not replace the other.

Is replacing a hardwired alarm a simple swap?

Sometimes. In a like-for-like swap, the new alarm uses the same plug and fits the same base. Turn off the breaker that feeds the alarms first and follow the manufacturer's instructions. Then the old one unplugs and the new one plugs in. If you are not sure which breaker it is, or you are not comfortable, call a licensed electrician.

New wiring is needed when:

  • The new alarm uses a different plug, so the connector in the ceiling box has to be rewired.
  • You want to add alarms in rooms or levels that have none.
  • You want to convert battery-only alarms to hardwired, interconnected alarms.
  • The wiring in the box is damaged, loose or has no signal wire.

Adding alarms, running new cable or converting battery alarms to hardwired generally needs an electrical permit and an inspection in New Jersey. Swapping an alarm for a like device usually does not. Your local construction office has the final say. See our smoke and CO detector installation page.

What does New Jersey require when you sell or rent a home?

Before a one- or two-family home is sold or gets a new tenant, New Jersey requires a Certificate of Smoke Alarm, Carbon Monoxide Alarm and Portable Fire Extinguisher Compliance. The local fire official or fire prevention bureau (the town's enforcing agency) issues it after an inspection. The requirements differ by when the home was built. A home built with hardwired, interconnected alarms is generally expected to keep them working that way. An older home may be allowed to use 10-year sealed battery alarms. Check with your local fire official before you buy alarms. Our NJ smoke and CO alarm certificate guide explains the process. If you failed an inspection, see how to fix a smoke alarm violation.

When should I call an electrician?

  • One alarm sounds but the others stay quiet.
  • Chirping or false alarms continue after a new battery and a cleaning.
  • You need alarms added, moved or converted to hardwired.
  • You see scorch marks or loose wires in the ceiling box.

How Gareffa Electric can help

Gareffa Electric is a family-owned, licensed NJ electrical contractor (NJ Electrical Contractor License #18578) with $2M in liability insurance. We are based in Nutley, NJ and serve Bergen, Hudson, Essex and Passaic counties. We repair and install hardwired, interconnected smoke and CO alarms. Every job is permitted in our name.

Book a $150 scheduled service call or a $350 same-day call. The service fee is credited on jobs over $1,500. Same-day or next-day dispatch is available. For planned work, book an estimate visit. Related guides: What is a GFCI outlet? and dedicated circuit installation.

FAQ

How long do hardwired smoke detectors last?

About 10 years. NFPA 72 says to replace smoke alarms 10 years after the date of manufacture.

Do hardwired smoke detectors have batteries?

Almost all do. Modern hardwired alarms have a backup battery so they keep working in a power outage. Some very old units have none, which is one more reason to replace them.

Why do all my smoke alarms go off at once?

They are interconnected. When one alarm senses smoke, it signals the others through a wire, so every alarm sounds.

Can I replace a hardwired smoke detector myself?

A like-for-like swap that uses the same plug and base is often a simple job. Turn off the breaker that feeds the alarms first and follow the manufacturer's instructions. If the plug is different, the wiring is damaged, you are adding alarms, or you are not sure which breaker it is, call a licensed electrician. Adding alarms, running new cable or converting battery alarms to hardwired generally needs an electrical permit in New Jersey. Swapping an alarm for a like device usually does not. Your local construction office has the final say.

Can I replace hardwired smoke alarms with battery-only alarms?

In general, no. A home built with hardwired, interconnected alarms is expected to keep them. Check with your local fire official.

Do I need a smoke alarm certificate to sell my house in NJ?

Yes, for one- and two-family homes. The local fire official or fire prevention bureau (the town's enforcing agency) issues a Certificate of Smoke Alarm, Carbon Monoxide Alarm and Portable Fire Extinguisher Compliance before a sale or a new tenancy.

Need hardwired smoke or CO alarms repaired or replaced? Call Gareffa Electric at (973) 662-4333. Monday to Saturday, 7 AM to 6 PM. Closed Sunday.